Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 161)

CAUTION:

Utilize care when removing muffler in Step 2. Muffler may contain very hot

10.

11.

water.

Remove muffler and place in sink

Lift and remove vent back and save for reuse.

Remove the 14 screws securing Danger Label panel and rear panels to side panels.

Save

panels and screws for reuse.

Remove weight from weight lifter and save

for reuse.

Disconnect the two (2) vent solenoid wires

from harness wires at insulated terminals

(See Figure 24).

Remove the four (4) screws securing vent

block and ball (if applicable) to vent assembly.

Save screws, block and ball (if applicable)

for reuse.

weight to regulate pressure.

Remove vent tube O-ring.

Remove the four (4) screws securing vent assembly to rear of fryer. Remove vent assembly

and vent block nut plate.

Save screws, vent assembly and nut plate for reuse.

Remove compression nut securing vent tube to cooking vessel. Note position of vent tube

prior to removal to ensure proper installation of new tube. Remove vent tube, ferrule and

nut.

Place compression nut over correct end of new vent tube. Place ferrule on vent tube in front

FIG. 24

FIG. 25

ferrule then start compression nut. DO NOT TIGHTEN. Place nut plate on vent tube.

WITHOUT BENDING matching end of

tube with hole in vent assembly. Replace

the four (4) screws securing vent assembly

to rear of fryer. NOTE: Vent tube must

protrude through vent assembly at least

l/2” ( See Figure 25).

13. Tighten compression nut securing vent

tube to cooking vessel.

14. Connect vent solenoid wires to harness

wires.

15. Place O-ring over vent tube and slide

back against vent assembly.

WINSTON

LIT.6710/REV.0/9-91

of compression nut and insert in bushing of cooking vessel. Apply silicone sealant around

12. Place vent assembly on rear of fryer noting position of vent tube. Adjust vent tube

models utilize a stainless steel

NOTE: Some 4-Head and 6-Head

vent ball (located on vent block) with

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 306 307

Kommentare zu diesen Handbüchern

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 161

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Friteusen Winston Industries PF56C