Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 153)

CAUTION:

Prior to applying final torque to screws in Step 12, verify solenoid wires are

not pinched between nut plate and vent assembly.

This could create a shorted

circuit causing potential equipment damage and /or personal injury.

12.

Place vent block on vent tube, line up nut plate behind vent assembly and replace the four

(4) screws securing block to vent tube and vent assembly.

13.

Connect vent solenoid wires to harness wires at insulated terminals.

14.

Drop vent ball (if applicable) down through waffle onto vent block.

15.

Insert weight into weight lifter.

16.

Place vent back onto vent assembly.

17.

Replace the seven (7) screws securing Danger Label panel and back panel to rear of fryer.

18.

Place muffler on fryer and place unit back into service.

REPLACE TEFLON SLIDE (ITEM NO. 62)

Tools:

Phillips Screwdriver #2; Needle nose pliers.

Procedure:

1. DANGER: Turn off electrical power and disconnect electrical power supply. If unit

is hardwired, CIRCUIT BREAKER MUST BE OFF.

CAUTION:

Utilize caution when removing muffler in Step 2.

Muffler may contain very

hot water.

2. Remove muffler and place in sink.

Lift and remove vent back.

Remove the seven (7) screws securing

Danger Label panel and either

left or right back panel (Servicer

preference) to rear of fryer and save for

reuse.

Remove weight and save for reuse.

6. Disconnect the two (2) vent solenoid

wires from harness wires at insulated

terminals (See Figure 13).

FIG. 13

WINSTON

LIT.6710/REV.0/9-91

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 306 307

Kommentare zu diesen Handbüchern

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 153

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Friteusen Winston Industries PF56C