Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 166)

CAUTION:

Prior to applying final torque to screws, verify solenoid wires are not pinched

between nut plate and vent assembly. This could create a shorted circuit

causing potential equipment damage and/or personal injury.

16.

Place vent block on vent tube, line up nut plate behind vent assembly and replace the four

(4) screws securing block to vent tube and vent assembly.

17.

Drop vent ball (if applicable) down through waffle onto vent block.

18.

Place weight down in weight lifter.

19.

Place vent back onto vent assembly.

20.

Replace the seven (7) screws securing back panel and Danger Label panel to fryer.

21. Place muffler onto vent back and place unit back into service.

REPLACE VENT SOLENOID (ITEM NO. 59)

Tools:

Phillips Screwdriver #2; Slotted Screwdriver; Nut Driver - 5/16”; Nut Driver

3/16”.

Procedures:

DANGER: Turn off electrical power and disconnect electrical power supply. If unit is

hardwired, CIRCUIT BREAKER MUST BE OFF.

CAUTION:

Utilize care when removing muffler in Step 2. Muffler may contain very hot

water.

Remove muffler and place in sink.

Lift and remove vent back.

Remove the seven (7) screws securing

Danger Label panel and right rear

panel to fryer. Save panels and screws

for reuse.

Remove weight from weight lifter.

Disconnect the two (2) vent solenoid wires

from harness wires at insulated terminals

(See Figure 31).

Remove

the four (4) screws securing vent

block to vent assembly. Save screws, block

and ball (if applicable) for reuse.

WINSTON

LIT.6710/REV.0/9-91

FIG.31

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 306 307

Kommentare zu diesen Handbüchern

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 166

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Friteusen Winston Industries PF56C