Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 157)

15. Replace the four (4) screws securing vent

assembly to rear of fryer. NOTE: Vent

tube must protrude through vent assembly

at least 1/2” (See Figure 19).

FIG. 19

17. Replace vent block on vent tube and

replace four screws securing vent block to

vent assembly. Be careful to align the

vent block square with the bottom of the

weight lifter.

REPLACE VENT TUBE O-RING

(ITEM NO. 43)

#2;

Tools: Phillips Screwdriver # 2; Needle Nose Pliers.

Procedure:

DANGER:

Turn off electrical power and disconnect electrical power supply. If unit is

hardwired, CIRCUIT BREAKER MUST BE OFF.

CAUTION: Utilize care when removing muffler in Step 2. Muffler may contain very

hot water.

2. Remove muffler and place in sink.

WINSTON

LIT.6710/REV.0/9-91

16. Place O-ring over vent tube and slide back

against vent assembly.

18. Connect vent solenoid wires to harness

wires at insulated terminals.

19. Drop vent ball (if applicable) down through

waffle onto vent block.

20. Place weight down in weight lifter.

21. Place vent back onto vent assembly.

22. Replace the seven (7) screws securing back panel and Danger Label panel to fryer.

23. Place muffler onto vent back and place unit back into service.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 306 307

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 157