Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 158)

13. Replace the seven (7) screws securing back panel and Danger Label panel to fryer.

FIG. 20

WINSTON

LIT.6710/REV.0/9-91

3. Lift and remove vent back.

panel (Servicer preference) to rear of fryer and save for reuse.

Remove weight from weight lifter.

Remove the four (4) screws securing vent block to vent assembly. Save screws, block and

ball (if applicable) for reuse.

NOTE:

Some 4-Head and 6-Head models utilize a stainless steel vent ball (located on vent

block) with weight to regulate pressure.

Remove defective vent tube O-ring and discard (See Figure 20).

Install new O-ring on vent tube.

CAUTION:

Prior to applying final torque to screws in Step 9, verify solenoid wires are

not pinched between nut plate and vent assembly. This could create as shorted

circuit causing possible equipment damage and/or personal injury.

Place vent block on vent tube, line up nut plate behind vent assembly and replace the four

(4) screws securing block to vent tube and vent assembly.

10.

Drop vent ball (if applicable) down through waffle onto vent block.

11.

Place weight down in weight lifter.

12.

Place vent back onto vent assembly.

14.

Place muffler

onto vent back and place unit back into service.

4. Rmove the seven (7) screws securing Danger Label panel and either left or right back

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 306 307

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 158