Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 148)

Move or rotate handle bar to open position. Lift lid above front block

and remove from

fryer.

Depress lid lock removing handle bar from lid and save for reuse.

Remove lid lock from lid assembly and save for reuse.

Lift lid and hold valve body with other hand.

Grasp the lid valve retainer with the other

hand and twist counter-clockwise to loosen.

Remove lid valve retainer. Note that lid valve spring has closed coil on one end and open

coil on the other. Open end goes toward lid. Save retainer and spring for reuse.

6. Remove lid valve and lower lid.

7. Using slotted screwdriver, carefully remove defective O-ring from groove in valve body.

Install new O-ring carefully pressing into groove in valve body.

Raise lid and insert lid valve into hole in lid. Make sure groove for lid lock is toward front.

Lean lid toward back of fryer.

10.

Holding valve body secure with one hand, install spring, (open coil toward lid). Using

other hand turning clockwise, carefully screw retainer into valve body. Utilizing only

hand pressure, completely tighten retainer to lid valve.

11. Lower lid and insert lid lock into groove in lid valve.

12. Depress lid lock, replace handle bar and place unit back into service.

REPLACE LID LOCK ASSEMBLY

(ITEM NO. 1)

Tools:

N/A

Procedure:

DANGER:

Turn off electrical power and disconnect electrial power supply. If unit is

hardwired, CIRCUIT BREAKER MUST BE OFF.

2. Move or rotate handle bar to open position. Lift lid above front block and remove from

Lift

fryer. Depress lid lock and remove handle bar from lid. Save handle bar for reuse.

Remove lid lock

from

lid assembly.

Install new lid lock on lid.

5. Depress lid lock, replace handle bar and place unit back into service.

WINSTON

LIT.6710/REV.0/9-91

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 306 307

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 148