Winston Industries PF56C Wartungshandbuch PDF herunterladen (Seite 143)

Remove lid gaining access to inside of cooking vessel.

NOTE:

If middle or bottom heater has to be replaced, the heater(s) above the one in

question must also be removed to permit access.

10.

11.

12.

Remove screw securing high limit thermostat bulb and clamp to top heater coil and save

for reuse.

Remove screw securing probe guard to second heater coil and save for reuse.

Remove the two (2) nuts securing each of the three (3) heater holders to fryer. Save nuts

and heater holders for reuse.

Using rubber mallet, tap heater ends

forward on inside of cooking vessel

allowing ferrule to be unseated from

bushing on outside of vessel (See

Figure 2).

CAUTION: Utilize care when removing

heater in Step 13 not to damage

thermostat bulb or temperature

Probe.

13.

14.

15.

16.

17.

18.

19.

20.

21.

Using wire cutters, remove ferrules from

both heater ends and remove heater.

Note position of offset in heater between

terminal ends to ensure proper installation

of new heater.

Positioning offsets in proper location, place new heater in cooking vessel inserting ends

through existing heater holes.

Replace the two (2) nuts securing each of the three (3) heater holders to cooking vessel.

Align coils to proper slots in heater holders and using a rubber mallet, gently tap heaters

securing them into position.

Install new ferrules onto heater ends. Apply small amount of silicone sealant around

ferrules and tighten compression nuts.

Replace insulation and strap.

Place new washer and correct heater

wire(s) on heater terminal and utilizing

caution, hold heater end behind wire

terminal and tighten hex nut (See

Figure 3).

Replace screw securing probe guard in

position. NOTE: Correct position of

guard is l/4” to right of probe tip.

Replace screw securing high limit

thermostat bulb and clamp to top

heater coil.

FIG. 2

FIG.3

WINSTON

LIT.6710/REV.0/9-91

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 306 307

Kommentare zu diesen Handbüchern

Keine Kommentare

Winston Industries PF56C Wartungshandbuch Seite 143

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Friteusen Winston Industries PF56C